DC Battery Charger Manual

Mini Balance Charger/Discharger/DC Power

- 19 -

NiMH/NiCd Battery Charge Setup

Select Program→Charge to enter Charge setup interface.

Note: Charge Mode has Normal and Reflex modes available; use reflex mode to charge the battery, it can reduce

the heat in the battery; please see charging principle on “Important Notes”.

NiMH/NiCd Battery Charge Advanced Setup

Click " " to enter NiMH/NiCd CHARGE OPTION SETUP interface, after setting click " " to return to the

previous interface.

Note: For the over-discharged NiMH/NiCd battery, the voltage may be close to 0V, tick Allow 0V Charging to allow

charge with 0V.

Tick Trickle Enable→Enable to activate trickle charge and set the parameters, after setting click" " to return to the

previous interface.

Note: Tick Enable to activate trickle charge.

Trickle charge means when the standard charge is completed, the charger will charge the battery with the setting

trickle current until the setting trickle timeout, then to stop the charging process.

NiMH/NiCd Battery Charge Safety Setup

Click " " to enter CHARGE SAFETY SETU interface, see details about setting on “LiPo/LiIo/LiFe Battery Charge

Safety Setup”.

NiMH/NiCd Battery Discharge Setup

Select Program→Discharge to enter Discharge setup interface.

Chg Current: 0.05A-30A; default: 2A

Chg Mode: Normal (default), Reflex

Sensitivity: 1mV-20mV; default: 3mV(NiMH), 5mV(NiCd)

Delay time: 0Min-20Min; default: 3Min

Trickle current： 0.02A-1A；default：0.05A

Trickle timeout：1Min-999Min; default: 5Min