DC Battery Charger Manual

Mini Balance Charger/Discharger/DC Power

- 24 -

X8 Parameters Setup

Parameters Setup

Press <> on the initial interface to enter the SYSTEM MENU interface, setting and testing of the system parameters,

storage and servo can be completed on this interface.

Charger Setup

After setting all parameters, click “ ” to save and return to the previous interface.

Temp. & Fans Setup

Select SYSTEM MENU→Charger Setup→Temperature & Fans to enter the setup interface, after setting click

“ ”to save and return to the previous interface.

Note: When the charger’s internal temperature reaches the ON Temperature, the fan will start automatically to

dissipate heat, and adjust speed automatically depends on the temperature increasing or decreasing. When the

temperature exceeds the Power Reduce temperature, the charger will stop increasing (temp. shown in orange) by

reducing the highest power limit. When the temperature reaches Shut Down temperature, the charger will shut

down. [When temp. >Shut Down-3, the temperature is shown flashing in red]. When the temperature is lower to

the ON Temperature, the fan will keep running within the setting time of OFF Delay Time.

1: Charger Setup Menu

2: Temp. & Fans Setup 3: Beep Tone Setup

4: LCD Setup 5: Input & Power Limit

6: Save & Load Configuration Setup

7: Language (Sprache) Setup 8: Calibration

9: Extra- Function

10: Log Files Manage 11: Servo Test

12: Pulse Test 13: Monitor

1:Temperature

Unit: Celsius (default), Fahrenheit

Shut Down: 65℃-80℃; default:80℃

Power Reduce: -5℃-20℃; default:-10℃

2:Cooling Fans

ON Temperature: 30℃-50℃; default:40℃

OFF Delay Time: 0Min-10Min; default: 2Min