DC Battery Charger Manual

Mini Balance Charger/Discharger/DC Power

- 8 -

X8 Setup & Use

X8 iCharger can charge/discharge LiPo、Lilo、LiFe、LiHv

、

LTO

、

NiHM、NiCd、NiZn or Pb batteries, this manual will

explain and introduce in detail the charger’s features, setup and use.

Power Supply Setup

The charger boots automatically when the power is turned on and the initial interface will display LOGO, charger

relevant information, power source and message etc.

System will delay 5 seconds after booting, during this period, press <> to change the input source type, while pressing

any other buttons to enter the initial interface.

Note: There are different parameter setting of these four types of power supply, the user can set in SYSTEM MENU→

Charger Setup→ Input &Power Supply; see details on “X8 Parameters Setup”.

After selecting the input power supply, confirm and enter the initial interface.

1: Logo 2: Model

3: Firmware version 4: Serial number

5: Input power voltage

6: Input power source 7: Hint message

When it is not Regenerative discharging,

the icon “ ” on the left bottom is grey;

When it is Regenerative discharging, the

icon turns to green