Use and Care Manual

54
3. INSERT FRONT WHEELS
• Turn Rollator frame over so that it rests on it’s
back (Juvo logo on front of padded seat should be
facing up), (see image 8).
• Insert the right front Leg-Wheel Part labeled ‘R’
into the frame tubing so that it matches up with
the letter ‘R’ on the frame leg, (see image 9).
• Press down on the push button and slide the
Leg-Wheel Part to your desired height position,
(see recommended seat height below).
• Repeat process, above, for left front Leg-Wheel
Part, labeled “L”.
• Make sure that the push button is fully engaged
in the hole for both Leg-Wheel Parts and that the
legs are even.
• Once desired height is achieved, insert one of the
(4) Leg-Wheel Adjustment Knobs, threading from
the outside for both leg-wheel parts, (see image
10). Tighten firmly.
4. ATTACH REAR LEG-WHEEL PARTS (WITH BRAKES):
• With Rollator still resting on it’s back, insert the
right rear Leg-Wheel Part, (with handle and brake),
labeled ‘R’ into the frame tubing so that the Leg-
Wheel Part matches up with the letter ‘R’ on the
frame leg, (see image 11).
• Press down on the push button and slide the rear
Leg-Wheel Part to your desired height position.
Refer to Recommended Seat Height Instructions,
next section.
• Insert one of the (4) Leg-Wheel Adjustment
Knobs, threading from the outside, (see image 10).
Tighten firmly.
• Repeat above steps to attach the second rear
Leg-Wheel Part (with handle and brake),
(labeled L).
• Turn Rollator right side up. Make sure the Rollator
is level and that all four Leg-Wheel Parts are in
the same position on the frame, and that the
(4) Leg-Wheel Adjustment Knobs are firmly
tightened.
5. RECOMMENDED SEAT HEIGHT:
• The user’s feet should be flat on the ground
when properly seated on the Rollator.
• There are three height adjustment positions
on the Juvo Rollator.
• Seat height on the Rollator is determined by the
positioning of the Leg-Wheel Parts, front and
back, on the frame.
• The first position, as the Leg-Wheel Part
engages the frame leg, is the tallest position,
for taller people.
• The second position, as the Leg-Wheel Part
enters the frame leg, is the middle position, for
people of medium height.
• The third position, as the Leg-Wheel Part enters
the frame, is the last position, for people of
shorter height.
• Make sure to test different positions to find the
proper height adjustment.
• Make sure that Rollator is level after adjustments
6. INSERT HANDLES:
• Take Handle attached to “R” Leg-Wheel Part
and insert handle tube into frame by sliding
into open tube in frame, (see image 12).
• To secure, thread one of the (2) Handle
Adjustment Knob bolts from the inside of
the frame, outward. The bolt head rests in an
opening of the same shape. Bolt head should be
flush with metal tube. Insert plastic washer and
Tightening Knob onto bolt from outward side of
tubing. Tighten firmly, (see image 13).
• Repeat above steps to insert second, “L” Handle.
8
9
10
11
13
12