OperationManual

Positioning Pin
Lens Cap
Lens Sheet
Front Cover
Top Panel
Positioning Pin
CN80Z0CN80F0
Motor
Lens Cap
Shift Lock
Screw
Shift Lock Screw
Mounting the Lens
When removing the lens cap, pull out without turning it.
Do not scratch or knock the lens surface.
Insert the lens with the motor facing upward.
Align the positioning pin of the projector (1 each on left
and right sides) with the positioning pin of the lens.
2 Remove the lens sheet attached to the lens
mount at the front cover
3 Remove the lens cap of the end to be inserted
into the projector
4 Insert lens into the mounting hole
5 Tighten the 5 screws using the hexagonal
wrench with a diagonal size of 3 mm (Bondhus
type recommended) to fasten the lens
7 Clamp the motor cable
When a zoom lens is used
When a short focal length lens is used
Connect the zoom motor cable (3 pin) to
“CN80Z0”, and the focus motor cable (2 pin) to
“CN80F0”.
Connect the focus motor cable (2 pin) to “CN80F0”.
6 Connect the motor cable
Retain these shift lock screws for future
use during transportation.
8 Unscrew the 2 shift lock screw
NOTE:
Remove the top panel if possible to ease the mounting
process. For details on how to remove the top panel, please
consult your authorized dealer or refer to the service
manual.
Remove the lens cap before projection.
9 Attach the front cover, and fasten using
the 6 screws using a Phillips screwdriver
CAUTION:
Before attaching the lens, check to make sure
that the power of the projector is not turned on and
the power cord is not connected. Failure to do so
may cause electric shock or injuries.
1 Unscrew the 6 screws using a Phillips
screwdriver to remove the front cover
5
4
1
2
6
7
Clamp
Zoom Motor Cable
Focus Motor
Cable
CAUTION:
Keep the cable away from the motor gear
when clamping the motor cable.