OperationManual
Table Of Contents
14
It is possible to control this unit by connecting it to a PC using an RS232C cross cable (Dsub 9pin).
The projector can be controlled by connecting it to a PC through the computer network with a LAN cable for control commands to
be sent to the projector.
● To control using the computer, connect to any one of the terminals (RS-232C, LAN or USB). Do not use the terminals at the
same time.
● Please use it after you have gained proper understanding from professional books or consulting the system administrator.
RS232C Specifications
● PC refers to the controller, such as a personal computer.
TCP/IP Connection
Before controlling via LAN, it is necessary to establish connection of the TCP layer by a “3way handshake”, followed by sending
out “PJREQ” and receiving “PJACK” within five seconds after the projector sends out “PJ_OK” for connection authentication.
If you are unable to complete sending within five seconds, or when “PJ_NG” or “PJNAK” is received, check the operating status of
the projector, followed by performing the steps again starting from establishment of a TCP connection,
External Control
Pin No. Signal Function Signal Direction
2 RxD Receive data PC B This unit
3 TxD Transmission data This unit B PC
5 GND Signal ground —
1, 4, 6-9 N/C — —
Mode Asynchronous
Data bit 8 bit
Parity None
Start bit 1
Stop bit 1
Data rate 19200 bps
Flow control None
15
69
This Unit
D6 D7D4 D5D2 D3D0 D1
Start bit Stop bit
Projector Control
Connection Authentication Procedure
PJACK
PJREQ
PJ_OK
Within 5 Seconds
Controlling PC
3-way Handshake
TCP Port No. 20554
Establishment of TCP Connection
Projector