User Guide

103
M
emo:
● To use Built-in MPEG4 Viewer of VN-V686WPU, install “ffdshow” that is open source codec. You can
download “ffdshow” from the Internet.
● The settings of Built-in Viewer are stored in the file named Cookie.
䡵 Searching and deleting cookie files
● Open [Tool] - [Internet Options] - [Advanced] of the Internet Explorer, and press the [Settings] button under
[Temporary Internet Files]. A new [Settings] will appear. Press the [View Files] button in this window. The
[Temporary Internet Files] window opens up and a list of files will be displayed. The file named
A cgi-bin B in
this list is the Cookie for Built-in Viewer.
● Deleting this file deletes the view settings, and the viewer will be initialized during the next startup.
B Stream Settings (continued)
Multicast Port You can change the multicast port number.
The default port number setting is 59152.
M
emo:
● This is enabled when A Start B is selected for the [JPEG Control] item on
the [Streaming] page.
● Specify the same value as the parameter that is set on the [Streaming]
page of VN-V686WPU. ( A Page 71)
C Operator Password Operator password is required to control VN-V686WPU and to get preset
position title from
VN-V686WPU . To use PTZ Controller or to display
preset position title, enter operator password.
[Enter user name and password] (A Page 34)
When the operator password has been entered under other settings, it
will be displayed as ●●●●●●.
D Cancel Cancels the changed settings and closes the setting screen.
E OK Saves the changed settings.
Click the [OK] button to enable the new settings and restart Built-in
viewer after closing the setting window.
This setting screen is used to set Built-in Viewer as a software on the computer, and does not apply to
settings of the VN-V686WPU unit.
When settings are changed, press the [OK] button to exit and restart the viewer.