Manual

In the following description, the buttons on the remote control unit are mainly used, however, you may use the

corresponding buttons on the front panel of the unit if available.

Turning on/off the unit

Press DVD STANDBY/ON (b/Ion the remote control unit or press STANDBY/ON _/I on the front panel.

OPEN

/CLOSE

<Z> o_

36 TV/V_D_O

REPEAT_HONECCANCELR_TU_N

(Z) (Z) (Z) (Z)

Tv4 Tv5 Tw

<33 <D <Z>/

6_b

DVDSTANDBY/ON

_/I

STANDBY/ON ...... I_ . .

• You can turn on the unit by pressing the I_ button. In this

case, the unit starts playback if the disc is set in the disc

tray.

• If no disc is set, "NO DISC" appears on the display window.

• You can turn on the unit by pressing the _A (OPEN/CLOSE)

button on the front panel. In this case, the disc tray opens.

NOTE

• Even if you press the DVD STANDBY/ON (b/I or STANDBY/ON (b/I button to turn off the unit, the unit is not disconnected from

the AC power source as long as it is connected to the wall outlet. This state is called the standby mode. In this state, the unit

consumes a very small amount of power.

Inserting and removing discs

1 Press A (0PEN/CLOSE) to open the disc tray.

2 Place the disc in the tray.

With the label side up

• To insert an 8-cm disc, place

it in the inner recess.

3 Press A (0PEN/CLOSE) to close the disc tray.

The unit reads the disc information and the corresponding opening display (depending on the disc type) appears

on the TV screen (See page 9).

NOTES

• Do not load a non-playable disc. For details about playable and non-playable disc types, see page 13.

• When loading a disc in the tray, be sure to position the disc inside the recess. Otherwise, the disc may be damaged when the

tray is closed, or the disc may not be removed from the unit.

• Do not use any stabilizer when playing back a disc.

• With some DVD VIDEO discs, the unit starts playback automatically after inserting the disc.

• If you insert a DVD VIDEO disc whose region code does not match the unit, "REGION CODE ERROR!" is shown in the DVD

opening display. For detail about the region code, see page 13.