User manual

8
Door reversal
Building-in
Dimensions of the recess
IKE 167-6 IKE 247-7
Height of housing (1) 880 1225 mm
Depth of housing (2) 550 550 mm
Width of housing (3) 560 560 mm
It is necessary that the niche is provided with a
conduct of ventilation having the following
dimensions:
Depth 50 mm
Width 540 mm
PR0
540
50
3
2
1
D132
The applianceÕs door has been locked in position for
transport by means of pins on both sides. According
to the door opening direction, remove relevant pins
at the top and at the bottom.
Attention
After completion of the door reversing
operation, check that the door gasket adheres
to the cabinet. If the ambient temperature is
cold (i.e. in Winter), the gasket may not fit
perfectly to the cabinet. In that case, wait for
the natural fitting of the gasket or accelerate
this process by heating up the part involved
with a normal hairdryer on a low setting.
B
A
1. Fit the appliance in the niche by making sure that
it stands against the interior surface of the unit on
the side where the door hinges of the appliances
are fitted. Insert the appliance until the upper strip
butts up against the unit (1) and make sure that
the lower hinge is in line with the surface of the
unit (2).
D022
1
2
2. Press in the joint covers between the appliance
and the kitchen furniture.