Data Sheet

Firmware programming

User is able to program their own developed ﬁrmware (with SDK) into PRBMD0x. The

programming procedure is as following, programming software, PhyPlusKit.exe (for

window) must be pre-installed, and UART-USB dongle may be needed:

1. Connect TM pin (pin 10) to 3.3V

2. Connect Tx and Rx (P09 and P10) pin to UART dongle

3. On PhyPlusKit, select the proper COM port and Baud Rate (default: 115200)

4. Click Erase to erase current ﬁrmware in PRBMD02

5. Load the ﬁrmware and click Write to program into PRBMD02

6. Connect TM pin to low level and apply reset. New ﬁrmware then starts to operate.

PRBMD02 DATASHEET 1.10

K-SOLUTION