User Guide

KALI AUDIO IN-Series Studio Monitor User’s Guide 14
First Time Setup
• Before you plug the speaker in, make sure that the power switch is in the OFF position
• Plug the speaker in
• Connect audio cables
◊ If you’re connecting RCA, make sure that dip switch #8 is switched UP to the ON posi-
tion
◊ If you’re connecting XLR or TRS, make sure that dup switch #8 is switched DOWN to the
OFF position
◊ Do not connect more than one audio cable to the speaker at the same time.
• Turn the volume knob counter clockwise as far as it will go
• Turn the speaker on
• Start playing material from your playback device at a low volume
• Slowly turn the volume knob clockwise to the center detente, -0 dB position. Make sure you hear what
you’re playing
• Set the boundary EQ for your application. Refer to page 11 above.
• Repeat these steps for every speaker you’re using.
• Sit in your listening position, and turn the volume up on your playback device to the desired level
• Enjoy your new studio monitors!
Climate Considerations
The IN-8 studio monitor’s enclosure is made of MDF wood and wrapped in vinyl, which is sensitive to heat
and humidity. The product should be kept and used in a climate-controlled environment. Exposure to direct
sunlight, moisture, or consistent humidity above 65% may cause the vinyl to peel and wrinkle. This is not
covered under warranty.
Standby Mode
IN-8s manufactured before March 27, 2020 have a standby mode. On these speakers, the speaker switches
to a low power state after 20 minutes of disuse. The LED on the front of the speaker will turn orange and the
speaker will stop passing audio.
Newer IN-8s and all IN-5s do not have a standby mode. To check the date your speaker was manufactured,
look at the 3rd-9th numbers of the serial number. This is the date of manufacture, in MMDDYY format. For
example, KL230327200327200005 was manufactured on 03/27/20, or March 27, 2020.
If your speaker’s standby mode is behaving incorrectly, please contact [e-mail]