User Manual

11
www.KALORIK.com
FT 47859 - 200605
Holding the basket by the handle, empty the food into a bowl or onto
a plate.
When a batch of food is ready, it is recommended to wait a couple of
minutes before the Digital Smart Fryer is ready to prepare another
batch. Do not heat the Digital Air Fryer for more than an hour.
Note: Because the rapid hot air technology instantly reheats the air inside
of the appliance, pulling the basket briefly out of the appliance during hot
air frying will not disturb the cooking process.
Tip: Sometimes, it is easier to divide cooking times into 2 phases for recipes
that require the basket to be shaken mid-cooking. If you set the timer to
half the required cooking time, you will hear the timer bell go off when you
must shake the ingredients. Please note that after shaking, you must set the
timer again to the remaining preparation time.
Tip: If you set the timer to the full cooking time, the timer bell will not go off
until cooking is completed. You can pull the basket out at any time to
check the cooking condition of the ingredients. The power will shut down
automatically and resume after you slide the basket back into the
appliance. Note that the timer does not stop counting down in this
situation.
Note: You may switch the appliance off at any time. To do so, simply press
the START key.
Note: It is suggested to wait a couple of minutes for the unit to cool down
before you start another cooking batch. Do not operate for more than an
hour.
Caution! The trivet, basket and ingredients will be hot! Depending on the
type of the ingredients in the Digital Smart Fryer, steam may escape out of
the unit. Be mindful of scalding and wear kitchen gloves for safety.
Tip: To remove large or fragile ingredients, you may use a pair of tongs to lift
the ingredients out of the basket. Tongs or utensils with heat-resistant plastic
tips are recommended as metallic tips or utensils may scratch the coating
of the basket.
IMPORTANT: If the fan is not operating once the product starts cooking (no
noise or airflow), please discontinue usage immediately and contact
Customer Service.