Operation Manual

Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International BELGIUM.
The page must reproduced and folded in order to obtain a mini
booklet A5 (+/- 150 mm width x 210 mm height). The page must be
folded in order to keep the good numbering when you turn the page
of the I/B . Don’t change the page numbering. Keep the language
integrity.
7 KA EL 5-9 - 050425
Assembly page 7/20
Fax [phone]

CONNECTION TO THE MAINS SUPPLY
The radiator should only be connected to an earthed socket installed in accordance with the
regulations.
Make sure that the supply voltage corresponds with the voltage marked on the rating label
(230V (AC)) and the rated electric current is not lower than 10A.
This product complies with all binding CE- labelling directives.
START UP
Before using the radiator for the first time, make sure the foot is fitted correctly underneath the
appliance. (see page 2) Never use the appliance if the foot is not fitted correctly.
When the appliance is switched on for the first time, a slight smell may be emitted. Please
ensure sufficient ventilation.
USE
 Turn the thermostat clockwise to a high position. When the pilot light is on, the heater is
activated.
 When your room reaches the desired temperature, the appliance stops heating. As soon
as the room temperature has dropped below the set temperature, the unit will switch itself
on automatically until the set temperature has been reached again. In this way, the room
temperature remains constant.
 If you want to change the room temperature setting, turn the thermostat clockwise to
raise temperature, or counter-clockwise to lower it.
 To switch off the appliance, turn the thermostat to its lowest position and unplug the
appliance.
OVERHEAT PROTECTION
This heater is protected with an overheat protection that switches off the appliance
automatically in case of overheat. In this case, unplug the appliance, wait about 10 minutes
for it to cool. Then switch it back on as described above. The appliance should operate
normally. Should the problem persist, please contact the nearest customer service.
CLEANING AND CARE
 Before cleaning the appliance, ensure it is disconnected from the power supply and has
cooled down completely.
 Do not clean the radiator with water and do not immerse it.
 The housing may be wiped with a slightly damp, lint-fee cloth.