Operating instructions

– 7
 Unlock the trigger safety and pull the le-
ver of the trigger gun.
 Set working pressure and flow rate
through turning (runless) at the pres-
sure- and amount regulation (B) (+/-).
 Release the lever on the trigger gun.
Appliance with pressure switch (B)
switches off.
Appliances without pressure switch go
into circuit operation.
 Release the lever of the trigger gun
again.
Appliance with pressure switch starts.
Appliances without pressure switch end
circuit operation.
 Release the lever on the trigger gun.
 Operate the trigger safety of the trigger
gun to secure the lever of the gun
against accidental triggering.
 Unlock the trigger safety and pull the le-
ver of the trigger gun.
 Set the appliance switch to "0".

Disconnect the mains plug from the socket.
 Shut off water supply.
 Activate trigger gun until device is pres-
sure-less.
 Operate the trigger safety of the trigger
gun to secure the lever of the gun
against accidental triggering.
ATTENTION
Frost will destroy the not completely water
drained device.
Store the appliance in a frost free area.
 Drain water.
 Pump in conventional frost protection
agents through the appliance.
Note:
Use normal glycol-based anti-freezing
agents for automobiles.
Observe handling instructions of the anti-
freeze agent manufacturer.
 Operate device for max. 1 minute until
the pump and conduits are empty.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
몇 CAUTION
Risk of personal injury or damage! Mind the
weight of the appliance during transport.
몇 CAUTION
Risk of personal injury or damage! Consider
the weight of the appliance when storing it.
 DANGER
Risk of injury by inadvertent startup of ap-
pliance and electrical shock.
Prior to all work on the appliance, switch off
the appliance and pull the power plug.
Appliance
without (A)
and (B)
 Set the appliance switch
to "I".
The appliance switches
on.
Interrupting operation
Short break
Longer break
Appliance
with hold-
er for trig-
ger gun (A)
 Place the trigger gun into
the holder.
The pump stops.
 Remove trigger gun from
the holder.
The pump starts.
Appliance
with pres-
sure
switch (B)
 Set the appliance switch
to "0/OFF“.
The pump is switched off.
 Set the appliance switch
to "I".
The pump is ready for op-
eration.
Appliance
without (A)
and (B)
 Set the appliance switch
to "0/OFF“.
The pump is switched off.
 Set the appliance switch
to "I".
The pump starts.
Turn off the appliance
Frost protection
If you cannot store it in a frost-free place:
Transport
Storage
Care and maintenance
22 EN