Operating instructions

English 7
AWT -C, AWT -C Fp operation
Control elements
1 Coin return
2 Coin slot
3 Tyre pressure button
4 Water dispenser button
1 Fuel pump nozzle
2 Lever
3 Valve connector
4 Target pressure display
5 Tire pressure display
6 Button +
7 Button -
8 Flat tyre button
9 No function
Drawing water
Checking tyre pressure
Filling flat tyres
If the tyre has no pressure, the device can-
not detect that the valve connector has
been connected to the valve.
Settings
Setting the run time
Note
The adjustable run time applies to the in-
sertion of one of the following coins:
● 50 Eurocents
● 50 British pence
● 1 Swiss franc
● 1 Polish złoty
● 5 Norwegian Kroner
Customer Service can set up different
types of coins.
1. Set the run time with the P I rotary knob.
Possible setting range of 30 seconds to
7 minutes.
1 Rotary knob P I
Note
Rotary knobs P II, P III and P IV have no
function.
Frost protection
Device with frost protection
1. Turn the frost protection switch "ON" at
temperatures below +5°C.
1 Frost protection switch
2 Frost protection heater
ATTENTION
Risk of damage
The frost protection is active only when the
main switch is “ON”.
When activating the frost protection, check
whether the main switch is in the “ON” po-
sition.
Note
The frost protection heater is not thermo-
stat-controlled. When switched on, the
heater is continuously in use.
Device without frost protection
In a device without frost protection, a shut-
down must be carried out if there is risk of
frost.
Shutting down
1. Close the water inlet
2. Drain the condensate in the compressed
air tank (see "Maintenance tasks").
3. Set the main switch to the "OFF" posi-
tion.
Shutdown in the case of potential
frost
1. Close the water inlet.
2. Remove water from the device and sup-
ply line.
3. Drain the condensate from the com-
pressed air tank (see “Maintenance
work”).
4. Set the main switch in "OFF" position.
6. Remove the valve connector.
7. Pull on the hose briefly and
feed the hose in via the auto-
matic hose reel.
1. Insert a coin in the coin slot.
2. Press the water dispenser but-
ton.
3. Hold the fuel pump nozzle in
the container opening.
Pull the fuel pump nozzle lever
until the desired filling level has
been reached.
4. Hang the fuel pump nozzle
back on the device.
1. Insert a coin in the coin slot.
2. Press the tyre pressure button.
3. Set the target tyre pressure
with the + and - buttons in the
target pressure display (upper
display).
4. Secure the valve connector on
the tyre valve.
The tyre pressure display (low-
er display) shows the tyre pres-
sure.
5. Wait until an acoustic signal in-
dicates that the tyre target pres-
sure has been reached.
6. Remove the valve connector.
7. Pull on the hose briefly and
feed the hose via the automatic
hose reel.
1. Insert a coin in the coin slot.
2. Press the tyre pressure button.
3. Set the target tyre pressure
with the + and - buttons in the
target pressure display (upper
display).
4. Secure the valve connector on
the tyre valve.
The tyre pressure display (low-
er display) shows the tyre pres-
sure.
5. Press the “Flat tyre” button.
6. Wait until an acoustic signal in-
dicates that the tyre target pres-
sure has been reached.
7. Remove the valve connector.
8. Pull on the hose briefly and
feed the hose via the automatic
hose reel.