Safety data sheet

Page 5/10
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 19.02.2021 Revision: 28.07.2020Version number 5
Trade name:
CarpetPro Cleaner iCapsol RM 768 OA
(Contd. of page 4)
52.0.1.1
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/
the chemical mixture.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation
·
Material of gloves
Butyl rubber, BR
·
Penetration time of glove material
The exact break trough time has to be found out by the manufacturer of the protective gloves and has to be
observed.
·
For the permanent contact in work areas without heightened risk of injury (e.g. Laboratory) gloves
made of the following material are suitable:
* butyl rubber 0,7 mm, 480 min
·
As protection from splashes gloves made of the following materials are suitable:
* nitril rubber 0,4 mm, 30 min (EN 374)
·
Eye/face protection
Tightly sealed goggles (EN 166)
*
SECTION 9: Physical and chemical properties
·
9.1 Information on basic physical and chemical properties
·
General Information
·
Physical state
Fluid
·
Colour:
Light yellow
·
Odour:
fresh
·
Odour threshold:
Not determined.
·
Melting point/freezing point:
0 °C
·
Boiling point or initial boiling point and boiling
range
100 °C
·
Flammability
Not applicable.
·
Lower and upper explosion limit
·
Lower:
Not determined.
·
Upper:
Not determined.
·
Flash point:
Not applicable
·
Auto-ignition temperature:
Product is not selfigniting.
·
Decomposition temperature:
Not determined.
·
pH at 20 °C
8.5
·
pH 1 % dem.
8.4
·
Viscosity:
·
Kinematic viscosity
Not determined.
·
dynamic at 20 °C:
4 mPas
·
Solubility
·
Water:
Fully miscible
·
Partition coefficient n-octanol/water (log value)
Not determined.
·
Vapour pressure:
Not determined.
(Contd. on page 6)
GB