TV Receiver User Manual

Hard Disk Recorder

While you are watching a pre-recorded programme, the previously

selected programme continues to be recorded.

For capacity reasons, only 400 single recordings are possible on

the 80 GB hard disk.

When started by EPG, the recording time automatically stops five

minutes after the end of the programme titles (see page 44).

Without EPG, the recording time is automatically pre-

programmed at two hours. Changes can be made using the



or by entering numbers.

If the hard disk is full, recording stops.

Fast Forward/Fast Rewind (no picture)

To forward or rewind the receiver rapidly without viewing the picture in

playback mode:

• Press



during playback of the recorded programme to

access the control console and press the pause button II.

• You can then press



(rewind) or



(fast forward) to rewind

or fast-forward with no picture (the longer you hold down the

button the faster the speed becomes).

• Use the



and



arrow buttons to jump to the end or back

to the start of the recording.

Playback

To play a recording from the hard disk, press the



button. The “HD

Program Guide” appears with a list of the recordings saved to the hard

disk. If there are no recordings stored on the hard disk, a message is

shown telling you so.

With the



buttons, you can select a currently running or previous

recording and start the playback by pressing



. The recorder plays

the recording you selected. “h***” appears on the LED display.