TV Receiver User Manual

Receiver-Features
7
Receiver-Features
The UFD 580 has two separate tuners for simultaneous reception of
two programmes, and a hard disk for recording and playback.
Depending on constellation, you can
• view one programme and record another to hard disk,
• play back one programme from the hard disk and record one
programme to hard disk, or
• record two programmes to hard disk and play back one
programme from the hard disk, or
• record two programmes to hard disk and view a programme from
one of the programme packages being received.
To take advantage of all these opportunities, complex operating
procedures are necessary. You should therefore read this operating
manual thoroughly.
Remote control RC 660
The RC 660 remote control supports up to four devices as well as the
receivers of the UFD 5xx (not UFD 552, 554, 558) and UFD 4xx
families.
To configure a receiver to an infrared code:
Switch on the relevant receiver.
On the remote control simultaneously press
Address 1 =

+

+

to
Address 4 =

+

+

To configure the remote control to an infrared code:
Switch to
Address 1 =

+

to
Address 4.=

+


+

(red) = Kathrein UFD 5xx code for remote control RC 400
The RC 600 and RC 650 remote controls cannot be replaced!