TV Receiver User Manual

Installation Menu
75
Antenna Setup
This menu is exclusively intended for service purposes and be used to
align the antenna in an emergency, if no measuring instruments are
available.
The first line is used to specify the satellite and the second line to
specify the transponder.
The polarisation of the received signal and the transmitted symbol rate
are shown on the next line.
The bars provide information about the strength (relative level) of the
signal and its quality. However, this information cannot be used to
draw any conclusions about the quality of the antenna system or the
cable connection.
Antenna Rotor/Positioner (DiSEqC™1.2)
For operation with a rotor (DiSEqC™1.2), select “On” on the
“Motor/Goto 0°” line.
On the next line, “Move/Save”, you can align the antenna to the east
or to the west using the

or

button. Press

to confirm. The
optimum setup can be viewed in the "Level" bar chart.
On the “Set Limit” line, you can press

or

to specify the
outermost aiming point (limited by a wall or other obstruction) in a
westerly or easterly direction.
Always read the operating manual supplied by the rotor manufacturer
thoroughly (particularly with regard to settings different to those
described above).