TV Receiver User Manual

Installation Menu
80
DiSEqC™ [UFO] Setup
You should only make changes in this menu if the receiver is
connected to a different reception system with different properties or if
changes have been made to the reception system.
You should therefore carefully follow the instructions for your Sat IF
system. However, before each change you should note the settings
on the form at the end of this operating manual.
Press

,

and

to access the DiSEqC™ menu.
22 kHz Signal
This menu option is used to specify whether the 22 kHz signal is to be
used to switch between the upper and lower frequency ranges for a
satellite (low/high) or between two satellite positions.
Tone Burst and DiSEqC™ Signal
If more than four control criteria are required in a reception system, a
DiSEqC™ control signal is required.
Which of the setting options - Tone Burst or DiSEqC™ - is required
depends on the components of the reception system.
You should therefore refer to the descriptions of the existing
components (switching matrices) of the reception system.
Pay attention to the
bar at the bottom of
the on-screen display!
It provides guidance
on what to do next.