TV Receiver User Manual

Receiver to Receiver Data Transfer
86
Receiver to Receiver Data Transfer
Your receiver is able to receive data from another receiver via its
RS232 port. For this, the two receivers are interconnected via a so-
called zero-modem cable. The transmitting receiver is the “master”,
and the receiving receiver is the "slave".
Preparations
The master and slave are first switched to standby mode and then
disconnected from the mains by pressing the power switch.
The data ports of the two receivers are interconnected by a zero-
modem cable.
The master is then switched on again.
Programme List Download
Simultaneously press Í (left arrow button) and “SELECT” under the
front flap of the master to transfer the programme list.
The slave can now be switched on. The transfer begins.
During downloading, the display of the master shows “t001 t002 ..
t00n”, while the slave correspondingly shows “r001 r002..r00n”.
The LED displays “
----” during the block transfer.
If both receivers indicate “Succ”, the download was successful.
Operating System Software Download
The procedure for downloading the operating system software is the
same as that described above.
Start the transfer of the operating system software by simultaneously
pressing Î (right arrow button) and “SELECT” under the front flap of
the master.
During downloading, the display of the master shows “t001 t002 ..
t00n”, while the slave correspondingly shows “r001 r002..r00n”.
The LED displays “
----” during the block transfer.
If both receivers indicate “Succ”, the download was successful.
If any problems occur in transmission, the master display will show
“F * * *”, with * representing a numerical value. In such cases, check
the cable connection and retry.
The receiver to receiver data exchange as described above must
only be carried out between devices of the same type, otherwise
malfunctions or total loss of the operating system software may
occur.
On no account may the receivers be switched off or the connection
interrupted during data transfer. This may result in data loss,
malfunctions or total failure of the operating system.
Always wait until the “Succ” or “F * * *” message appears on the
display.