Technical data

936.3222/-/1207/7.8e
2.6.2 Selecting the TV standard
The “TV Standard” parameter allows selection between the standard B/G,
D/K and I.
Note:
B/G:
7 MHz or 8 MHz channel raster, audio carrier: 5.500 MHz and 5.742 MHz
D/K: 8 MHz channel raster, audio carrier: 6.5 MHz
I: 8 MHz channel raster, audio carrier: 6.0 MHz
*** UFO 394-I ***
244.25 MHz Standard B/G
HF on Level -7
16:9 Letterbox
B/G
2.6.3 Switching the output signal on/off
The output channel can be switched on/off via the “Output RF on/off”
parameter.
*** UFO 394-I ***
244.25 MHz Standard B/G
HF on Level -7
16:9 Letterbox
on
2.6.4 Setting the common output level
The parameter “Output Level” allows the output level of the output channel to
be continuously varied in 40 steps (approx. 20 dB).
The setting limits are designated “Min” and “Max”.
*** UFO 394-I ***
244.25 MHz Standard B/G
HF on Level -
16:9 Letterbox
-7
2.6.5 Selecting the picture format
Selecting the procedure for reception of 16:9 wide-screen format:

Letterbox

Pan & Scan (always 4:3)
*** UFO 394-I ***
244.25 MHz Standard B/G
HF on Level -7
16:9 PanScan
Letterbox
2.7 Selecting the audio mode
Selecting the audio mode.
The scroll buttons allow selection of the following audio modes:
“Auto”, “Mono”, “Stereo”, “2-channel”, “2-channel A” and “2-channel B”
I 1236 MHz 27.5 MS
TV Das Erste deu
Outp. CH12 244.25MHz
Auto Vol+0dB AV
Auto
Note:
- In “Auto” the audio mode is set by the SAT signal
- In “2-channel A” only channel 1 is transmitted during 2-channel reception
- In “2-channel B” only channel 2 is transmitted during 2-channel reception