Product Manual

1. Before connecting the garden hose to the

Pressure Washer, connect the garden

hose to the water source and run water

through the hose to flush out any debris.

Shut off the water at the source.

2. Attach garden hose to the Pressure

Washer coupling inlet at the lower back of the unit.

Ensure that the threads are aligned properly and that the

connection is secure. Securely tighten the nut by hand.

3. Turn on the water source.

4. Connect the Pressure Washer GFCI power cord to a

dedicated electrical outlet.

5. Press the RESET button on the GFCI to ensure its proper operation.

Outlet capacity must be 120V, 60HZ and minimum 15 AMP.

For best result, use a short garden hose (30 ft. [9 m] or

less length), cold water (less than 100°F [37°C]) and adequate pressure (no

less than 50 PSI).

POWER SUPPLY CONNECTION

KEEP all electrical connections dry and off the ground.

NEVER touch the plug with wet hands.

NEVER cut or remove grounding blade (round longer pin) on GFCI

attachment plug.

OPERATING THE PRESSURE WASHER

ALWAYS wear approved safety glasses when operating Pressure

Washers. Spray can splash back or propel objects, including

incorrectly attached accessories.

The high pressure stream of water that this equipment produces can cut

through skin and its underlying tissues, leading to possible amputation.

Spray gun traps high water pressure, even when the motor is stopped and water

is disconnected, which can cause injury.

Kickback from spray gun can cause you to fall.