Product Manual

Fan Pattern Rotation – Turn the cone section of the

gun to change the orientation of the fan pattern.

ATTACHING NOZZLES TO SPRAY WAND

Never place hands in front of nozzle. Never grasp hose or fittings during

Pressure Washer operation. Never attempt to attach or remove spray wand or

hose fittings while Pressure Washer system is pressurized.

Turn off Pressure Washer and lock the Gun Trigger before attempting to

change pressure nozzles.

1. To attach, pull back on slip ring and insert nozzle until it

securely snaps into place.

2. To detach, slide down slip ring on female quick-

disconnect to eject the nozzle.

3. Hold the gun securely with both hands. Point the gun

in a safe direction. Make sure that the gun safety (the

button above the trigger) is unlocked and squeeze the

trigger to allow any air that is trapped inside the unit and

hoses to escape. Continue to squeeze the trigger until a

steady stream of water comes from the nozzle.

4. Turn on the ON/Off switch on the front of the

Pressure Washer. NOTE: Motor does not start until

trigger is pulled.

5. Point the gun in a safe direction and squeeze the

trigger to start motor and water flow.

Make sure wand is SECURELY tightened to Gun. If the wand is not securely

locked into place, it could be ejected under high pressure when operating

the gun, possibly causing injury or damage.

USAGE TIPS:

• For most effective cleaning, keep spray nozzle 8 to 24

inches (20 cm to 60 cm) away from cleaning surface.

• If you get spray nozzle too close, especially using

high pressure mode, you may damage surface being

cleaned.

• DO NOT get closer than 6 inches (15 cm) when

cleaning tires.

SLIP RING

PUSH TO

UNLOCK

SQUEEZE