Product Manual

SHUTTING DOWN THE PRESSURE WASHER
The Pressure Washer motor runs only when the trigger is engaged. To shut off the
Pressure Washer:
1. Release spray gun trigger.
2. Move unit’s ON/OFF switch to OFF position.
IMPORTANT: Releasing the trigger will shut off the motor but does not shut off
electrical power to the unit.
3. Remove and store quick change pressure washer tip.
4. Turn off water supply.
5. ALWAYS point spray gun in a safe direction and squeeze spray gun trigger to
relieve built up pressure in the unit.
Spray gun traps high water pressure, even when motor is
stopped and water is disconnected.
6. Engage trigger lock on spray gun when not in use. Place the gun in its holder
on the side of the unit.
7. Disconnect GFCI plug from outlet and wrap power cord around the Power Cord
Hook at the back of the pressure washer. Store the GFCI plug inside its housing
in the centre of cord intake.
8. Disconnect pressure washer from water supply and store the unit (see
MAINTENENCE section).
PRESSURE HOSE PUTAWAY & STORAGE
After completion of washing/cleaning job, it is highly recommended to disconnect
the hose from the unit and the gun and drain the water completely from the hose
and store in the hose reel. Draining water from the pressure washer prior
to storage can prevent mineral buildup
inside the system which can reduce the
performance of the pressure washer.
1. Put one end of the hose inside the reel with
one hand and rotate the reel handle with
other hand until the hose completely is
wrapped around the reel. Fig. 1
2. Secure the end of the
hose under the holding
tab. Fig. 2
Fig. 1
Fig. 2
15