Product Manual

• If you have the nozzle too far away from the surface being washed, the cleaning

will not be as effective.

IMPORTANT: DO NOT get closer than 15 cm (6 inches) when cleaning.

MAINTENANCE

Regular maintenance will improve performance and extend life of Pressure Washer.

Some adjustments will need to be made periodically to properly maintain the Pressure

Washer. All service and adjustments should be made at least one time each season. It

is important that the maintenance chart below be followed.

MOVING AND STORAGE

After each application or winter storage follow these instructions:

1. When finished using the Pressure Washer, you must first drain and rinse the

detergent tank.

2. Turn the machine OFF and squeeze the trigger to release the trapped pressure

inside of the machine.

3. Remove both the garden hose and pressure hose from the unit.

4. Turn ON the machine and allow it to run for 5 seconds. (This will clear out most

of the water trapped in the pump).

5. Unplug the machine and store in a dry, climate controlled environment.

NOTE: Do not store the machine or accessories in a place where the temperature could

drop below 40°F (4°C).

AFTER EXTENDED STORAGE

Scale deposits may form in the pump when it is not used for some time. This causes

the motor to hesitate or not start up at all.

1. Do not plug the unit into electrical outlet or connect the pressure hose to the unit.

2. Connect garden hose to the unit and allow the water to exit from high pressure

outlet for a few seconds to rinse the system.

3. Shut off the water.

4. Connect pressure hose to the gun and then lock hose safety device.

CONNECTIONS

Connections (fittings) on Pressure Washer, pressure hose, gun and spray wand should

be cleaned regularly and lubricated with non-water soluble grease to prevent leakage

and damage to the o-rings.