Product Manual

NOZZLE

The nozzles should be lubricated with non-water soluble grease or light oil regularly.

Clogging of the nozzles causes the pump pressure to build up too high and cleaning

is required.

1. Make sure Pressure Washer On/Off switch is

set to Off and spray gun trigger is locked.

2. Clear blockage in nozzle by inserting the nozzle

cleaning needle (provided) through centre hole.

3. After cleaning, remove the needle from nozzle

and store for future use.

LUBRICATION

This Pressure Washer does not require any maintenance on the pump or motor.

Both assemblies are pre-lubricated and sealed, requiring no additional lubrication.

A small amount of oil leakage is normal. If oil leakage

persists or becomes worse, the unit may need to be serviced by qualified repair

personnel.

WATER INLET SCREEN (FILTER)

The Pressure Washer is equipped with a water inlet

screen to protect the pump from foreign debris.

CAREFULLY remove debris from the screen using a

nonabrasive and dull object (finger or Q-Tip). Make sure

screen is not torn or broken.

Do not operate Pressure Washer without screen filter in

place. Impurities entering pressure pump can cause internal damage.

COOLING SYSTEM

The air louvers, located in and around the Pressure Washer housing must be kept

clean and free of any obstructions to ensure proper air cooling of the motor and

pump during operation.

SCREEN