User Guide

Note: All jumpers on
the KBMG must be set
before installing the KBMG
finger-safe cover.
E. Installing the KBMG Multi-
speed Board onto the
KBMG – The terminal block
located on the bottom of
the KBMG Multi-Speed
Board plugs onto the six (6)
header pins where TB1 was
removed from the KBMG.
The two (2) holes on the
back of the KBMG Multi-
Speed Board snap onto the
finger-safe cover. Use the
two (2) 6-32 X 1
3
⁄4” screws,
that were previously
removed, to secure the
KBMG Multi-Speed Board
to the KBMG. Do not over
tighten these screws or
damage may result to the
KBMG Multi-Speed Board and the KBMG. See Figure 7, on page 6.
Installation is now complete.
9
KBMG Finger-Safe Cover. Remove Panel
(cut 7 places) to Install KBMG Multi-Speed Board.
FIGURE 10 – REMOVING KBMG FINGER-SAFE
COVER PANEL