User Guide

A. Direction Selection (R/F) – All R/F Jumpers are fac-

tory set to the “F” position for forward operation.

For reverse operation, set the desired preset speed

Jumper to the “R” position. See Figure 3.

B. Speed Range Selection (HI, LO) – All HI and LO

Jumpers are factory installed for full motor speed

range. For more precise adjustment over a nar-

rower speed range (high, medium, or low) set the

HI and LO jumpers as shown in Figure 4.

C. Enable Selection (J1) – Jumper J1 is fac-

tory installed to enable the control. To con-

nect an Enable Switch to Terminal Block

TB1, remove Jumper J1. See Figure 5 and

Figure 12, on page 10.

R/F Set for

Forward Direction

(Factory Setting)

R/F Set for

Reverse Direction

FIGURE 4

SPEED RANGE

SELECTION

(HI/LO)

HI/LO Set for Full Speed Range

(Factory Setting)

HI/LO Set for High

Speed Setting

HI/LO Set for Low

Speed Setting

HI/LO Set for Med.

Speed Setting

R/F

% Base Speed 0 - 100 50 - 100 0 - 50 33 - 66

FIGURE 3 – DIRECTION

SELECTION (R/F)

FIGURE 5 – ENABLE SELECTION (J1)

J1 Set for

Enabling of Control

(Factory Setting)

J1 Removed for

Enable Switch