Assembly Instructions

14
Periodic inspections by a competent person are recommended by the manufacturer. In UK/Europe these are required under Regulation 5 of the Workplace (Health, Safety & Welfare)
Regulations, the Work at Height Regulations and Provision and Use of Work Equipment Regulations.
The frequency will depend upon the environment, location and usage but should be at least every 12 months.
• Walk and visually inspect the complete installed product in relation to the general client’s needs. Establish if any modifications and/or additional products are required to reflect any
refurbishment requirements or additional plant & equipment which have been installed and require access.
• Check installation configuration is complete as per the original installation drawing/plan.
• Ensure the product has not been modified or tampered with by unauthorised persons.
• Check the functionality of the product.
• Check the spring is correctly tensioned.
• Check all fixings are in place, greased and sufficiently torque.
• Check the general height and level of the product.
• Any galvanised components showing signs of corrosion should be wire brushed thoroughly and galvanised spray/paint applied as appropriate.
If rusted significantly, take digital photographs and include these in the inspection report.
• Inspect aluminium/stainless steel and powder coated product surfaces and note any imperfections or general degradation.
• Check fixings to walls/structures including cat ladder clamps are in place, greased and sufficiently torqued.
• Check system plaque position & mark up to reflect date of the next required inspection. Establish if additional plaques are required due to any refurbishment works.
Kee Gate Recertification