Assembly Instructions
11
A. Align the fixing plate on internal face of the opening, so
that the rails of the Safety Gate match up with the top of the
Guardrail System. Select the correct U Bolt & pass it through
the Steel Safety Clamp & around the support leg/structure and
feed through the top holes of the fixing plate.
TOOLS REQUIRED
You will need the following in order to install the
Kee Gate:
• Marker Pen
• Tape Measure
• 1No 15/16” Ring Spanners
• 3/16” Allen Key
• 1No ½” socket
• No 11/16”mm socket
• 1No 15/16”mm socket
• Torque Wrench 10- 60 Nm approx
• Small Magnetic Spirit Level
Mounting Gate to Upright
Establish that the gate will close in direction of hazard!!
Failure to do so could result in Death or serious injury.
D. Torque all nuts/U Bolts to 25Nm using the 11/16” or ½”
socket and torque wrench.
C. Select the correct U Bolt & pass it through the Steel Safety
Clamp & around the support leg/structure and feed through the
top holes of the fixing plate. Using a ½” or 11/16” flat washer
and nut connect the U bolt to the Support Leg/Structure and
tighten.
B. Using a 11/16” or ½” flat washer and nut connect the U
bolt to the Support Leg/Structure and tighten.
E. To extend the gates width to the required opening simply
loosen the hex nuts and bolts on the top guardrail using a
3/16” Allen Key and ½” socket.
Mounting and tensioning gate spring