INSTRUCTION MANUAL COMMERCIAL GRADE REFRIGERATOR MODEL:ZCK-163 BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS. Kegco has a policy of continuous improvement on its products and reserves the right to change materials and specifications without notice KEGCO 8520 Miralani Dr., San Diego, CA 92126 www.kegco.
Table of Contents Safety Tips ........................................................................................................................... 3 Installation Instructions ........................................................................................................................... 4 Caster Installation ........................................................................................................................... 4 Changing Door Swing Direction .................
Safety Tips Before using this appliance, it must be properly positioned and installed as described in this manual, so please read carefully. To reduce the risk of fire, electrical shock or injury when using the appliance, follow these basic precautions. • • • • • • • • • • • • • • • • • • • Plug into a grounded 3-prong outlet. Do not under any circumstances cut or remove the third ground prong from the power cord supplied, do not use an adapter, and do not use an extension cord.
Installation Instructions BEFORE USE: • Remove the exterior and interior packaging. • Before connecting the unit to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. • Clean the interior surface with lukewarm water using a soft cloth. • This appliance is designed for free standing installation.
Changing Door Swing Direction Step 1: Lay the unit on its back. Step 2: Remove the kickplate by removing the three retaining screws (FIG. 1). Step 3: Remove the four screws located on the lower door hinge (FIG. 2). Step 4: Pull the door downward until it releases from the upper hinge pin. Step 5: Remove the plastic screw cap from the top left hand side (FIG. 3) and install it on the top right hand side of the door frame. Step 6: Unscrew the upper door hinge pin (FIG.
Operation Instructions The refrigerator should be placed in an area where the ambient temperature is between 32-100 degrees Fahrenheit. If the ambient temperature is above or below this range, the performance of the unit may be affected. For example, placing your unit in extreme cold or hot conditions may cause the interior temperatures to fluctuate.
Cleaning and Maintenance Refrigerator maintenance: • Ice build-up will defrost automatically, so there is no need to defrost the refrigerator. • Defrost water collects inside of the drain trough and passes through a drain outlet in the rear wall into a drain pan situated above the compressor, where it will evaporate.
Technical Specifications Dimensions 35" H x 24" W x 24.25" D Weight 124.56 lbs. Voltage / Frequency 115v / 60 Hz Running Amps 2.3 A Operating Temperature 36°F - 46°F Maximum Ambient Temperature www.kegco.
Warranty Information WHAT IS COVERED LIMITED ONE-YEAR WARRANTY: For one year from the date of purchase by the original owner, Kegco will, at its option, repair or replace any part of the unit, which proves to be defective in material or workmanship under normal use. During this period Kegco will provide all parts and labor necessary to correct such defects free of charge, so long as the unit has been installed and operated in accordance with the written instructions in this manual.