Use and Care Manual

www.kegco.com 6 1-888-980-4810
Setting the Temperature
The Kegco Kegerator is able to maintain the proper storage temperature for beer, soda, and other cold beverages,
provided it is installed correctly in the proper environment. Avoid opening and closing the door of the cooler too often
to ensure a consistent temperature inside the unit.
To set the desired temperature, press SET for 1 second or until the value starts to flash, then
adjust the value using the UP or DOWN button. Press SET again to confirm the new value.
For rapid cooldown of the contents, you can set a continuous cycle by holding the UP and
DOWN buttons together for more than 3 seconds.
To turn the unit ON/OFF, press UP for more than 3 seconds. The control and defrost algorithms are now disables and
the display will read OFF alternating with the current temperature inside the unit as measured by the temp sensor. To
engage the manual defrost, hold the DOWN button for more than 3 seconds. It will still show the current temperature.
CAUTION: Leaving the temperature control on the coldest setting may cause the evaporator coil to freeze and ice up.
This will eventually result in a warmer cabinet temperature.
If you are going on vacation, you may leave the cooler operating during vacations of less than three weeks. If the
appliance will not be used for several months, you should remove all items and turn off the appliance. Clean and dry the
interior thoroughly. To prevent mold growth, leave the door open slightly, blocking it open if necessary.
Keg Configuration
Kegco XCK-1 Kegerators are large enough to fit a full-size keg or multiple smaller kegs, giving you the flexibility to serve a
combination of different beers from one kegerator. Some configurations may require mounting the CO2 tank outside
the cabinet.