User Manual

Section 2: General operation Series 2200 Programmable DC Power Supplies Reference Manual
2-10 2200S-901-01 Rev. A/November 2011
Primary
menu
Secondary menu
First option
Additional
option(s)
Allows you to ...
the instrument will advance to each
step only after it receives a trigger
signal.
Repeat allows you to set or edit
number of steps.
List Steps allows you to indicate the
number of steps in the list.
>User
>Reset User
No
Yes
Reset User menu selections to the
factory default configuration.
>Output Recall
Off
Turn output recall mode off.
On
Set power output state to that which
was in use before power was last
turned off. See Recall the power
supply ON/OFF output state at power
on (on page 2-20) for more
information.
>Save Last
On
Save last operating parameters in
use before turning instrument off.
Restores saved parameters when
instrument turned on. See Recall the
power supply operating parameters at
power on (on page 2-21) for more
information.
Off
Turns save last mode off.
>Key Beep
Off
Turns off key press notification
sound.
On
Turns on key press notification
sound. See Setting the key sound (on
page 2-21) for more information.
>Knob Lock
Off
Unlocks navigation wheel .
On
Locks navigation wheel . See Lock
the navigation wheel (on page 2-22)
for more information.
>System
>Reset System
No
Yes
Reset System menu selections to the
factory default configuration.
>Port Mode
Trigger
Set port mode input to trigger. You
must also set the trigger source (Trig
Source).
RI/Def
Set port mode input and output to
RI/Def. You must also set the remote
inhibit mode (RI mode).
Digital
Set port mode input and output to
digital. This setting is for
programmable interface commands
described in Commands listed in
alphabetical order (on page 4-2).
>Trig Source
Manual
Set rear panel port mode to manual
trigger.
External
Set rear panel port mode to external
trigger.
Bus
Set rear panel port mode to bus
trigger.