User Manual

Section 2: General operation Series 2200 Programmable DC Power Supplies Reference Manual
2-22 2200S-901-01 Rev. A/November 2011
Lock the navigation wheel
The Knob Lock control can be used to lock the navigation wheel so it cannot be used to change
settings or to select menu items.
To lock the navigation wheel :
1. Press Shift and Menu (1) to access the configuration menus.
2. Use the arrow keys, numeric keypad, or navigation wheel to select >User.
3. Press Enter.
4. Use the arrow keys, numeric keypad, or navigation wheel to select >Knob Lock.
5. Press Enter.
6. Use the arrow keys, numeric keypad, or navigation wheel to select >On or >Off.
7. Press Enter.
8. Press Esc to exit the menu system.
The default value for the Knob Lock control is Off.
Using local sense
Configuring the power supply for local sense allows connection to the device under test with two lead
wires, but does not compensate for voltage drop in the leads.
To configure for local sense:
1. On the rear panel terminal strip, install wires between DRIVE + and SENSE +, and between
DRIVE - and SENSE -. You may also use the included shorting clip described in Rear panel at a
glance.
2. Connect to your device under test using two wires from either the front panel binding posts or the
rear panel DRIVE + and DRIVE - terminals.