User Manual

Series 2200 Programmable DC Power Supplies Reference Manual Section 2: General operation
2200S-901-01 Rev. A/November 2011 2-27
Figure 9: IEEE-488 connector
To allow many GPIB connections to other instruments, stack the cable connectors. Two screws are
located on each connector to ensure that connections remain secure. The figure below shows a
typical connection scheme for a multi-unit test system.
Figure 10: Series 2200 multiple parallel connections
To avoid possible mechanical damage, stack no more than three connectors on any one unit. To
minimize interference caused by electromagnetic radiation, use only shielded IEEE-488 cables.
Contact Keithley Instruments for shielded cables.