User Manual

Series 2200 Programmable DC Power Supplies Reference Manual Section 4: Command reference
2200S-901-01 Rev. A/November 2011 4-9
*RCL (no query form)
Restores the state of the power supply from a copy of its settings
stored in the setup memory. The settings are stored using the *SAV
command. If the specified setup memory is deleted, this command
causes an error.
Group
Save and Recall
Syntax
*RCL <NR1>
Related
Commands
*SAV (no query form) (on page 4-10)
Arguments
<NR1> is an integer value in the range from 0 to 40 and specifies
the location of setup memory.
Examples
*RCL 3
sets the power supply to settings stored in memory location 3.
*RST (no query form)
This command resets the power supply to default settings, but
does not purge any stored settings.
Sending the *RST command does the following:
 Returns the power supply settings to the defaults described in
Default setup (on page 2-34).
 Clears the pending operation flag and associated operations
The *RST command does not change the following items:
 State of the USB or GPIB interface
 Calibration data that affects device specifications
 Current GPIB power supply address
 Stored settings
 Output queue
 Service Request Enable Register settings
 Standard Event Status Enable Register settings
 Power-On Status Clear flag setting front-panel LOCK state
Group
Status
Syntax
*RST