User Manual

Series 2200 Programmable DC Power Supplies Reference Manual Section 4: Command reference
2200S-901-01 Rev. A/November 2011 4-21
[SOURce:]OUTPut:RI:MODE
This command sets the input mode of the RI (remote inhibit) input
pin. In order for this command to be effective, the rear panel TTL
input and output must be configured in RI/DFI mode using the
[SOURce:]DIGital:FUNCtion (on page 4-12) command.
Group
Source
Syntax
[SOURce:]OUTPut:RI:MODE {OFF|LATChing|LIVE}
[SOURce:]OUTPut:RI:MODE?
Related
Commands
[SOURce:]DIGital:FUNCtion (on page 4-12)
Arguments
OFF: The level of the RI input pin does not affect the output state of
the power supply.
LATChing: When the level of the RI input pin changes from high to
low, the output of power supply turns off.
LIVE: The output state of power supply changes according to the
level of the RI input pin. While the level is TTL high, the output will
be on. While the level is TTL low, the output of the power supply
will be off.
Returns
OFF|LATC|LIVE
Examples
OUTP:RI:MODE LATC
OUTP:RI:MODE? might return OFF, which would indicate that
remote inhibit is not controlling the output of the instrument.