User Manual

Section 4: Command reference Series 2200 Programmable DC Power Supplies Reference Manual

4-20 2200S-901-01 Rev. A/November 2011

[SOURce:]OUTPut:PON[:STATe]

This command configures the power supply to power up with its

output turned off, or to return the output to the state it was in when

it powered down.

Group

Source

Syntax

[SOURce:]OUTPut:PON[:STATe] {RST|RCL0}

[SOURce:]OUTPut:PON[:STATe]?

Arguments

RST sets the power supply to power-up with output off.

RCL0 sets the power supply to power-up with the output in the last

state before power was removed.

Returns

RST|RCL0

Examples

OUTPUT:PON RST

OUTPUT:PON? might return RCL0, which would indicate that the

instrument will return to the present output state if the power is

cycled.

[SOURce:]OUTPut:PROTection:CLEar (no query form)

This command clears a trip condition caused by over voltage (OV),

over temperature (OT), or remote inhibit (RI).

Group

Source

Syntax

[SOURce:]OUTPut:PROTection:CLEar

Commands

[SOURce:]VOLTage:PROTection[:LEVel] (on page 4-26)

Examples

OUTP:PROT:CLE