User Manual

Section 4: Command reference Series 2200 Programmable DC Power Supplies Reference Manual
4-24 2200S-901-01 Rev. A/November 2011
[SOURce:]OUTPut:TIMer[:STATe]
This command turns the output timer function on and off. When the
timer is activated and a duration is set, the output of the power
supply will turn off automatically if left on longer than the specified
duration. In order to ensure proper operation of the output timer, the
power supply must be turned on by using the
[SOURce:]OUTPut:TIMer[:STATe] (on page 4-24) command.
Group
Source
Syntax
[SOURce:]OUTPut:TIMer[:STATe] {0|1|ON|OFF}
[SOURce:]OUTPut:TIMer[:STATe]?
Related
Commands
[SOURce:]OUTPut:PROTection:CLEar (no query form) (on page 4-
20)
[SOURce:]OUTPut:TIMer:DELay (on page 4-23)
[SOURce:]OUTPut[:STATe] (on page 4-22)
Arguments
0 or OFF turns the output timer off.
1 or ON turns the output timer on.
Returns
0|1
Examples
To start timer, first send OUTPUT:TIMER:STATE ON, then send
OUTPUT:STATE ON.
To end timer (turn timer off), send OUTPUT:TIMER:STATE OFF.