User Manual

Section 4: Command reference Series 2200 Programmable DC Power Supplies Reference Manual

4-26 2200S-901-01 Rev. A/November 2011

[SOURce:]VOLTage:PROTection[:LEVel]

This command sets the over voltage protection (OVP) threshold

level.

Group

Source

Syntax

[SOURce:]VOLTage:PROTection[:LEVel]

{<voltage>|MIN|MAX|DEF}

[SOURce:]VOLTage:PROTection[:LEVel]?

Commands

[SOURce:]VOLTage:PROTection[:LEVel] (on page 4-26)

[SOURce:]VOLTage:RANGe (on page 4-28)

Arguments

where:

<NRf> is a flexible decimal that specifies the OVP threshold,

ranging from 0 to the maximum OVP level

<units> ::={V|mV}

MIN: sets the minimum OVP level (1 V).

MAX: sets the maximum OVP level, which is approximately 10%

higher than the maximum output voltage rating of the power supply.

DEF: sets the OVP level to the default level, which is equal to MAX.

Returns

<NR2> is the OVP threshold in volts.

MIN: set to minimum OVP level.

MAX: set to maximum OVP level.

Examples

VOLT:PROT 30V

VOLT:PROT? might return 30, which would be the OVP threshold in

volts.