Installation guide

Option B_No Waste Disposer- No Air Gap
]o Fit rubber end of drain hose to
waste tee and cut if needed.
NOTE: Do not cut ribbed section.
2= Attach rubber end of drain hose to
waste tee with a large drain hose
c}amp (provided). Use p}iers to
squeeze c}amp open and move into
position. If the drain hose was cut,
use a 11/2,, to 2" (3.8 to 5 cm) screw-
type clamp (not provided).
Option C, Waste Disposer - With Air Gap
Drain trap
Helpful T}p: Remove disposer knockout plug.
]. Using a hammer and screwdriver,
knock p}ug into disposer.
2. Use needle-nose pliers to remove
plug.
3. Connect rubber end of drain hose
to air gap and cut if needed.
NOTE: Do not cut ribbed section.
4=
Attach drain hose to air gap with
large drain hose clamp (provided).
Use p}iers to squeeze clamp open
and move into position. If the drain
hose was cut, use a 11/2"to 2" (3.8 to
5 cm) screw-type c}amp (not
provided).
=
Use a rubber hose (not provided)
with screw-type clamps (not
provided) to connect from air gap
to disposer inlet.
Option D_No Waste Disposer - With Air Gap
_ _ii__ i_ii!
]. Connect rubber end of drain hose
to air gap and cut if needed.
NOTE: Do not cut ribbed section.
2=
=
Attach drain hose to air gap with
large drain hose clamp (provided).
Use p}iers to squeeze clamp open
and move into position. If the drain
hose was cut, use a 11/2"to 2" (3.8 to
5 cm) screw-type c}amp (not
provided).
Use a rubber hose (not provided)
with screw-type clamps (not
provided) to connect from waste tee
to air gap.
]1