Installation guide

Installation Instructions
STEP 12 |CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODES AND ORDINANCES.
The drain hose molded end will fit 5/8”, 3/4” or 1” diameter
connections on the air gap, waste tee or disposer. Cut on the
marked line as required for your installation.
* If a longer drain hose is required, add up to 42” of length
Cutting Lines
My
ZAI az3 | ex Ficure U
na | ee | 8/8 oe
IMPORTANT: Do not cut corrugated
portion of hose
for a total of 10 ft. to the factory installed hose. Use 5/8” or
7/8” inside diameter hose and a coupler to connect the
two hose ends. Secure the connection with hose clamps.
« Secure the drain hose to the air gap, waste tee or disposer
with clamps.
Vi
Hose C|
Coupler osemramp
Hose Clamp Figure V
NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED
10 FEET FOR PROPER DRAIN OPERATION.
DRAIN LINE INSTALLATION
* Connect drain line to air gap, waste tee or disposer using
either previously determined method.
Method 1 - Air gap with waste tee or disposer
aa A
Waste Tee Installation Disposer Installation
Figure W
Method 2 —- High drain loop with waste tee or dis-
poser
Fasten to underside
_za of countertop
Fasten to underside
all countertop
Waste Tee Installation Disposer Installation
Figure X
IMPORTANT -
a—Remove
When connecting drain line to disposer, Disposer
check to be sure that drain plug has been Plug
removed. DISHWASHER WILL NOT DRAIN
IF PLUG IS LEFT IN PLACE.
TIP: Avoid unnecessary service call charges. Always be sure
disposer drain plug has been removed before attaching
dishwasher drain hose to the disposer.
10