® Top-Mount Refrigerator Refrigerador s{ _,,, R_frig_rateur 2225401 con montaje superior superpos_ Sears Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. Sears Canada, Inc., Toronto, Ontario, Canada M5B 2B8 www.sears.com www.sears.
TABLE OF CONTENTS WARRANTY WARRANTY ..................................................................................... 2 ONE-YEAR FULL WARRANTY REFRIGERATOR SAFETY .............................................................. Proper Disposal of Your Old Refrigerator .................................... REFRIGERATOR INSTALLATION ................................................. Unpacking .................................................................................... Location Requirements ......
REFRIGERATOR SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. All willsymbol. follow the safety alert symbol and either the word "DANGER" or Thissafety is themessages safety alert "WARNING.
REFRIGERATOR INSTALLATION Explosion Hazard Keep flammable materials and vapors, such as gasoline, away from refrigerator, Failure to do so can result in death, explosion, or fire, Removing packaging materials • Remove tape and glue residue from surfaces before turning on the refrigerator. Rub a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry. Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue.
Read all directions carefully before you begin. IMPORTANT: ElectricalShockHazard Pluginto a grounded3 prongoutlet. Donot removegroundprong. Donot usean adapter. Donot usean extensioncord. Failureto follow these instructions can • If you turn the refrigerator on before the water line is connected, turn the ice maker OFR • All installations • Use copper tubing and check for leaks. Install copper tubing only in areas where temperatures will remain above freezing.
. 7. 8. Fasten the shutoff valve to the cold water pipe with the pipe clamp. Be sure the outlet end is solidly in the V4in. drilled hole in the water pipe and that the washer is under the pipe clamp. Tighten the packing nut. Tighten the pipe clamp screws carefully and evenly so washer makes a watertight seal. Do not overtighten or you may crush the copper tubing. Slip the compression sleeve and compression nut on the copper tubing as shown.
Door Reversal 4. Remove door handle sealing screws. Move to opposite side of refrigerator door as shown (see Graphic 4), 5, Remove door handle seal screw front. Move to opposite side of refrigerator door as shown (see Graphic 7), 6, Remove door stop, Move to opposite side of refrigerator door as shown (see Graphic 5). 7, Position refrigerator handle on opposite side of the refrigerator door as shown (see Graphic 6-3), Drive top two screws in handle first.
1. Cabinet Hinge Hole Plugs Top Hinge I 1. Door Hinge Hole Plug 1. 546"Hex-Head Hinge Screws i J / / I I I 1. Top Hinge Cover 2. s/_,,Hex-Head Hinge Screws 3. Top Hinge 1. Flat-Head Handle Screws 2. Freezer Door Handle _0 Center Hinge / J / / 1. Door Handle Sealing Screws Front View 1. Center Hinge 2. s/_,,Hex-Head Hinge Screws Bottom Hinge Side View d / / Im --p 1. Door Stop Screw 2. Door Stop I e _ll ° 2 1. Door Handle Seat Screw Front J 1, Bottom Hinge 2.
_,_,,_ Door Closing Your refrigerator and one on the want the doors the instructions has two front adjustable rollers - one on the right left. If your refrigerator seems unsteady or you to close easier, adjust the refrigerator's tilt using below: 1. Plug into a grounded 2. Move the refrigerator into its final position. 3. Remove the base grille (see "Base Grille" earlier in this section).
Mid-setting "4" REFRIGERATOR USE In order to ensure proper temperatures, you need to permit airflow between the refrigerator and freezer sections. As shown in the illustration, cool air enters through the bottom of the freezer section and moves up. Most of the air then flows through the freezer section vents and recirculates under the freezer floor. The rest of the air enters the refrigerator section through the top vent. IMPORTANT: Give your refrigerator time to cool down completely before adding food.
REFRIGERATOR Turning the ice maker on/off NOTE: Do not force the wire shutoff arm up or down. = To turn the ice maker on, simply lower the wire shutoff arm. NOTE: Your ice maker has an automatic shutoff. As ice is made, the ice cubes will fill the ice storage bin and the ice cubes will raise the wire shutoff arm to the OFF (arm up) position. = Your model may have some or all of these features. Features that can be purchased separately as product accessories are labeled with the word "Accessory.
C_s_ _ _,_ _ To slide the shelf from side to side, lift up on the front of shelf and slide to the desired location. Lower shelf to the level position. NOTE: You do not have to remove small items from the shelf before moving it from side to side. You may need to remove larger items. _ _ _ _ _ M_, _,,,_ _ _ _,, _s _ _, _,__ _ __,,_ _"_ _ _ Drawers To remove and replace a drawer:. 1. Slide drawer straight out to the stop. Lift the front of the drawer and slide it out the rest of the way. 2.
To remove and replace the meat drawer cover (Style 2 plastic): 1. Remove the meat drawer. Tilt the cover up at the front and pull it forward and out. 2. Replace the meat drawer cover by fitting the notches and rear edge of the cover over rear and center crossbars on the shelf. Lower cover into place and replace the meat drawer. Slide the meat drawer temperature control forward to make the meat drawer less cold or backward to make the drawer more cold.
Your model may have some or all of these features. Features that can be purchased separately as product accessories are labeled with the word "Accessory." Not all accessories will fit all models. If you are interested in purchasing one of the accessories, please call the toll-free number on the cover or in the "Assistance or Service" section. To remove and replace the shelf:. 1. Remove the shelf by lifting the entire shelf slightly and move it all the way to one side.
REFRIGERATOR CARE NOTE: Can racks may be purchased as an Accessory models. for some To remove and replace the racks/bins: 1. Remove the rack/bin by lifting it and pulling it straight out. 2. Replace the rack/bin by sliding it in above the desired support and pushing it down until it stops. Explosion Hazard Use nonflammable The utility compartment and tray slide from one side to the other for more flexible storage. The tray fits on either side of the utility compartment or partially underneath it.
5. There is no need for routine condenser cleaning in normal home operating environments. If the environment is particularly greasy or dusty, or there is significant pet traffic in the home, the condenser should be cleaned every two to three months to ensure maximum efficiency. If you need to clean the condenser: • Remove the base grille (see "Base Grille" or "Door Removal" section).
TROUBLESHOOTING The refrigerator • Try the solutions suggested here first in order to avoid the cost of an unnecessary service call. seems to make too much noise The sounds may be normal for your refrigerator. See the "Normal Sounds" section. The ice maker is not producing Your refrigerator • Is the power cord unplugged? Plug into a grounded 3 prong outlet. • Has a household fuse or circuit breaker tripped? the fuse or reset the circuit breaker.
The water dispenser will not operate properly Has the water system not filled? The water system needs to be filled the first time it is used. Use a sturdy container to depress the water dispenser until water begins to flow. Dispense and discard 2 to 3 gal. (8 to 12 L) of water. This will take approximately 6 to 7 minutes and will help clear air from the line. Additional flushing may be required in some households. See the "Water Dispenser" section.
PROTECTION AGREEMENTS Master Protection Agreements Congratulations on making a smart purchase. Your new Kenmore ®appliance is designed and manufactured for years of dependable operation. But like all products, it may require preventive maintenance or repair from time to time. That's when having a Master Protection Agreement can save you money and aggravation. Purchase a Master Protection Agreement now and protect yourself from unexpected hassle and expense.
i1111111111111iJ ........ i_i;ii!ii!ii!ii!ii!ii!ii!ii! YourHome iiiiiiiiiiiii For repair-in your home-of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! For the replacement parts, accessories and owner's manuals that you need to do-it-yourself. For Sears professional installationof home appliances and items like garage door openers and water heaters. 1-800-4-MY-HOME ® (1-800-469-4663) Call anytime, day or night (U.S.