E L ! T Top-Mount Use ® Refrigerator '_ _"_(,,:,_k(] ,,_ Refrigerador R_frig_rateur 2225403 E con montaje superior superpos_ Sears Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. Sears Canada, Inc., Toronto, Ontario, Canada M5B 2B8 www.sears.com www.sears.
TABLE OF CONTENTS WARRANTY WARRANTY ..................................................................................... 2 ONE-YEAR FULL WARRANTY REFRIGERATOR SAFETY .............................................................. Proper Disposal of Your Old Refrigerator .................................... REFRIGERATOR INSTALLATION ................................................. Unpacking .................................................................................... Location Requirements ......
REFRIGERATOR SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. All willsymbol. follow the safety alert symbol and either the word "DANGER" or Thissafety is themessages safety alert "WARNING.
REFRIGERATOR INSTALLATION Explosion Hazard Keep flammable materials and vapors, such as gasoline, away from refrigerator, Failure to do so can result in death, explosion, or fire, Removing packaging materials • Remove tape and glue residue from surfaces before turning on the refrigerator. Rub a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry. Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue.
Cold water supply Connect the ice maker to a cold water line with water pressure between 30 and 126 psi. If you have questions about your water pressure, call your utility company. Connecting ElectricalShockHazard Pluginto a grounded3 prongoutlet. Donot removegroundprong. Donot usean adapter. Donot usean extensioncord. Failureto follow these instructions can to Water Line 1. Unplug refrigerator or disconnect 2, Turn OFF main water supply. Turn ON nearest faucet long enough to clear line of water.
3. Check forleaks. Tighten anyconnections (including connections atthevalve) ornutsthatleak. Door Reversal (optional) (Graphics follow these instructions.) Round-Head Handle Screw Door Handle Screw Hole Plug Door Hinge Hole Plug Cabinet 1. Tube Clamp 2. Copper Tubing 3. Compression 4. Valve Inlet Nut 1. Remove %8 in. hex-head hinge screws from handle side and move them to opposite side (see Graphic 1-1). 4. The ice maker is equipped with a built-in water strainer.
1. Cabinet Hinge Hole Plugs Top Hinge 1 Door Hinge Hole Plug \ \ Removal of DoorStops t \ \ Top Hinge Cover s/_ ,, Hex-Head Hinge Screws iiiiiiiiiiiiiii iiiiiiiiiiiiii \ Top Hinge Center Hinge 1. DoorStop iiiiiiiiiiiiiii;!!!i:i:i:i:ii B DoorStopScrew iiiiiiiiiiiiiiiiiiiiiii:i I_ i!i!i!i!i!i!i!i!i!i!i!i!i i [] Freezer Door Door Handle Reversal ....... 2 1. Door Handle Sealing Screws 2. Door Handle Screw Hole Plugs 1. Center Hinge 2.
Door Closing Your refrigerator and one on the want the doors the instructions Please read before using the water system. has two front adjustable rollers - one on the right left. If your refrigerator seems unsteady or you to close easier, adjust the refrigerator's tilt using below: 1. Plug into a grounded 2. Move the refrigerator into its final position. 3. Remove the base grille (see "Base Grille" earlier in this section).
5. Turn on the ice maker by opening the freezer door and lowering the wire shutoff arm as shown. Please refer to the "Ice Maker" section for further instructions on the operation of your ice maker. • Allow 24 hours to produce the first batch of ice. • Discard the first three batches of ice produced. • Depending on your model, you may want to select the maximum ice feature to increase the production of ice.
Mid-setting "3" Mid-setting "4" 0'= JmB Cut Hazard Use a sturdy glass when dispensing ice or water. Failure to do so can result in cuts. IMPORTANT: Give your refrigerator time to cool down completely before adding food. It is best to wait 24 hours before you put food into the refrigerator. If you add food before the refrigerator has cooled completely, your food may spoil.
NOTE: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. 5. Use a sturdy container to depress the water dispenser bar until the water begins to flow. Flush the water system by dispensing and discarding 2 to 3 gal. (8 to 12 L) of water. Cleaning the system will take approximately 6 to 7 minutes and will help clear air from the line. Additional flushing may be required in some households.
REFRIGERATOR Your model may have some or all of these features. Features that can be purchased separately as product accessories are labeled with the word "Accessory." Not all accessories will fit all models. If you are interested in purchasing one of the accessories, please call the toll-free number on the cover or in the "Assistance or Service" section. To slide the shelf from side to side, lift up on the front of shelf and slide to the desired location. Lower shelf to the level position.
• Fruit: Wash, let dry and store in refrigerator in plastic bag in crisper. Do not wash or hull berries until they are ready to use. Sort and keep berries in original container in crisper. • Vegetables with skins: Place in plastic bag or plastic container and store in crisper. Crisper Cover To remove the crisper(s) cover:. 1. Remove crisper(s). Hold the glass insert firmly with one hand and press up in the center of the glass insert until it rises above the plastic frame.
Depending on your model, you may have a one, two or three piece bin. Eggs may be stored in the egg tray or loose in the bin. To remove and replace the freezer floor: 1. Lift both back "fences" up and out. NOTE: Store eggs in a covered container for long-term storage. If your model does not have an egg storage bin, store eggs in their original carton on an interior shelf. 2. Remove the freezer floor by pulling it out about 1 in. (2.
REFRIGERATOR CARE NOTE: Can racks may be purchased as an Accessory models. for some To remove and replace the racks/bins: 1. Remove the rack/bin by lifting it and pulling it straight out. 2. Replace the rack/bin by sliding it in above the desired support and pushing it down until it stops. Explosion Hazard Use nonflammable The utility compartment and tray slide from one side to the other for more flexible storage. The tray fits on either side of the utility compartment or partially underneath it.
5. There is no need for routine condenser cleaning in normal home operating environments. If the environment is particularly greasy or dusty, or there is significant pet traffic in the home, the condenser should be cleaned every two to three months to ensure maximum efficiency. If you need to clean the condenser: • Remove the base grille (see "Base Grille" or "Door Removal" section).
TROUBLESHOOTING The ice maker is not producing • Has the ice maker just been installed? Wait 72 hours for full ice production to begin. Once your refrigerator is cooled, the ice maker should produce 70-120 cubes every 24 hours. • Is the freezer temperature cold enough to produce ice? Wait 24 hours after hook-up for ice production. See the "Using the Control(s)" section. • Is the wire shutoff arm in the OFF (arm up) position? Lower the wire shutoff arm to the ON (arm down) position.
Is the water shutoff valve not turned on or the water line connected at the source? Be sure the water shutoff valve is turned on and the water source is connected to the refrigerator. See the "Water Supply Connection"section. There is interior moisture • Is the water shutoff valve clogged or incorrectly installed? See the "Water Supply Connection"section. If clogging or installation is not a problem, call for service or contact a plumber.
The Master Protection Agreement also helps extend the life of your new appliance.
PRODUCT DATA Cyst Interior Water Filtration System Model WFI-NLCS200/NLCS200 Tested and certified by NSF International against ANSI/NSF Standard 42 for the reduction of Chlorine (Class I) Taste and Odor and against ANS/NSF Standard 53 or the reduct on of Lead, Cysts and Turb d ty. Capacity: 200 gallons (757 liters), Service flow rate: 0.5 GPM (189 L/min.) @ 60 psi Substance Reduction Aesthetic Effects U.S.
i1111111111111iJ ........ i_i;ii!ii!ii!ii!ii!ii!ii!ii! YourHome iiiiiiiiiiiii For repair-in your home-of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! For the replacement parts, accessories and owner's manuals that you need to do-it-yourself. For Sears professional installationof home appliances and items like garage door openers and water heaters. 1-800-4-MY-HOME ® (1-800-469-4663) Call anytime, day or night (U.S.
