Manual

ManualsBrandsKenmore ManualsDryerOfficial Kenmore dryer feature sheet

_-_ D D DRYER OPERATING INSTRUCTIONS

OPERATING STATUS

KEYS

imml

_lJl LINT SCREEN

B SAFETY DOOR

SWITCH

_ ERFONM,_ICE

GUIDE LABEL

_ MODEL NO. PLATE

ll]l YCLESELECTOR

CONTROL

B START

CONTROL

r r,

If you need SERVICE or PARTS for your Kenmore dryer:

Be ready to give your Sears Service Department the model number, serial number and date of

purchase. Write in below. The plate U with model and serial numbers is located behind the

dryer door.

IM I

MODEL NO. SERIAL NO. DATE OF PURCHASE

ELECTRIC

MODEL 64281

GAS

MODEL 74281

Summary of content (4 pages)

PAGE 1
_-_ D D DRYER OPERATING INSTRUCTIONS m ll]l YCLESELECTOR CONTROL I B START CONTROL OPERATING STATUS KEYS I r _lJl LINT SCREEN B SAFETY DOOR SWITCH _ ERFONM,_ICE GUIDE LABEL _ MODEL NO. PLATE r, I imml If you need SERVICE or PARTS for your Kenmore dryer: Be ready to give your Sears Service Department the model number, serial number and date of purchase. Write in below. The plate U with model and serial numbers is located behind the dryer door. MODEL NO. IM SERIAL NO.
PAGE 2
How to dry a load of laundry t_ Clean lint screen before each load. (_ Set Cycle Selector Control Ill. Put laundry into dryer and shut the door. _ _ Push the Start Controlll[I to start your dryer. [_ II I::I mvNt fm Remove load when dry. I| r"a_ Ill Cycle Selector Control El Start Control Use this control to select the proper drying method for the type of items in the load. The control can be set for Timed Drying or Air.
PAGE 3
Ill CYCLE SELECTOR CONTROL NORMAL Cycle PERMANENT PRESS Cycle Use this cycle to get up to 120 minutes of drying time at high heat followed by a 5 minute (approx.) cooldown. Use this cycle to get up to 50 minutes of drying time at high heat followed by a 10 minute (approx.) cooldown. • Set the Cycle Selector Control to the amount of time you want in the Normal Cycle. • Push the StartControl. • Set the Cycle Selector Control to the amount of time you want in the Permanent Press Cycle.
PAGE 4
FEATURES Ik']lLint Screen IB Performance Keep the lint screen clean. A lint-clogged screen will slow down the flow of air. This makes drying time longer and wastes energy. Clean the lint screen before each load as follows: Located inside the dryer door. Gives information on what to do if dryer does no.t perform normally. NOTE:. If dryer drum is stained, clean it with a damp cloth and mild detergent. !. With dryer off, remove the screen by pulling straight up. 2. Roll the dry lint off the screen.