Manual

ManualsBrandsKenmore ManualsDryerOfficial Kenmore dryer feature sheet

S_ AIIS =o==o,==.v°o,===

l l

END-OF-CYCLE

SIGNAL FEATURE

OPERATING STATUS

KEYS

BUNT SCREEN

I _F_'Y DOOR

swrrcH

l_ PERFORMANCE

GUIDELABEL

O MODEL NO. PLATE

, i

If you need SERVICE or PARTS for your Kenmore dryer:

Be ready to give your Sears Service Department the model number, sedal number and date of

purchase. Write in below. The plate IM with model and serial numbers is located behind the

dryer door.

.1=10.

MODEL NO. SERIAL NO.

DATE OF PURCHASE

ELECTRIC

MODEL 64681

GAS

MODEL 74681

Summary of content (4 pages)

PAGE 1
m ! S_ AIIS =o= =o,==.v°o,=== l l ! END-OF-CYCLE SIGNAL FEATURE i OPERATING STATUS KEYS I I BUNT SCREEN I , I i _F_'Y DOOR swrrcH ! l_ i O PERFORMANCE GUIDELABEL MODEL NO. PLATE ! I ! I ! ! If you need SERVICE or PARTS for your Kenmore dryer: Be ready to give your Sears Service Department the model number, sedal number and date of purchase. Write in below. The plate IM with model and serial numbers is located behind the dryer door. .1=10. MODEL NO. M SERIAL NO.
PAGE 2
How to dry a load of laundry b_ Clean lint screen before each load. (_ Set Cycle Selector Control I! thePUt door.laundry into dryer and shut _) PUsh the Start Control Il! to start your dryer. t-_ I r-2_ I_Qmwz --_ Remove load when dry. lmP Ill Cycle Selector Control El Start Control Use this control to select the proper drying method for the type of items in the load. The control can be set for Automatic or Timed Drying, Touch Up or Air.
PAGE 3
CYCLE SELECTOR CONTROL AUTO DRY I Normal/Permanent Cycle Press Use this cycle for most loads of sturdy clothes or synthetic, permanent press items. Clothes are dried at high heat followed by a 10 minute (approx.) cooldown. When the dryness selected is reached the dryer goes into cooldown then a buzzer sounds. If you do not unload the dryer, it goes into Wrinkle Guard I automatically. • Set the Cycle Selector Control to the (_) which is good for most fabrics.
PAGE 4
FEATURES il Lint Screen Performance Guide Label Keep the lint screen clean. A lint-clogged screen will slow down the flow of air. This makes drying time longer and wastes energy. Clean the lint screen before each load as follows: 1. With dryer off, remove the screen by pulling straight up. 2. Roll the dry lint off the screen. Do not wet the screen or lint; wet lint is hard to remove. Located inside the dryer door. Gives information on what to do if dryer does not perform normally. Model No.