Manual

ManualsBrandsKenmore ManualsDryerOfficial Kenmore dryer feature sheet

13rl DRYEROPE.ATING,NSTRUCTIONS

I m

END-OF-CYCLE

SIGNALFEATURE

CYCLE SELECTOR

CI_TROL

OPERATINGSTATUS

SYMBOLS

I UNTSCREEN

B ERFORMANCE

GUIDE LABEL

_1 MODEL NO, PLATE

m m

If you need SERVICE or PARTS for your Kenmore dryer:

Be ready to give your Sears Service Department the model number, serial number and date of

purchase. Write in below. The plate [] with model and serial numbers is located behind the

dryer door.

1,0. IM I

_ MODEL NO. SERIAL NO. DATE OF PURCHASE

i i

ELECTRIC

MODEL 64691

GAS

MODEL 74691

Summary of content (4 pages)

PAGE 1
3rl DRYER OPE.ATING ,NSTRUCTIO I m END-OF-CYCLE SIGNALFEATURE CYCLE SELECTOR CI_TROL OPERATINGSTATUS SYMBOLS I B _1 UNTSCREEN ERFORMANCE GUIDE LABEL MODEL NO, PLATE I i m m If you need SERVICE or PARTS for your Kenmore dryer: Be ready to give your Sears Service Department the model number, serial number and date of purchase. Write in below. The plate [] with model and serial numbers is located behind the dryer door. 1,0. _ MODEL NO. IM SERIAL NO.
PAGE 2
How to dry a load of laundry _ Clean lint screen before each load. (_ SetCycleSelectorControl l! _'I Put laundry into dryer and shut the door. [-_ Push the Start Control Ill to start _ your dryer. -_ Remove load when dry. !! J OUl"f _ 14L(IT man tri'_Llrf Ill Cycle Selector Control E1 Start Control Use this control to select the properdrying method for the type of items in the load. The control can be set for Automatic or Timed Drying, Touch Up or Air.
PAGE 3
CYCLE SELECTOR CONTROL AUTO DRY I Normal/Permanent Cycle Press AIR DRY Cycle Use this cycle to get up to 20 minutes of drying time in room temperature air. Use this setting for items that will not tolerate heat, such as plastics, foam rubber, etc. and for airing and fluffing items such as pillows. Use this cycle for most loads of sturdy clothes or synthetic, permanent press items. Clothes are dried at high heat followed by a 10 minute (approx.) cooldown. • Do not dry these items with heat.
PAGE 4
FEATURES Performance Guide Label [[1 Lint Screen Keep the lint screen clean. A lint-clogged screen will slow down the flow of air. This makes drying time longer and wastes energy. Clean the lint screen before each load as follows: 1. With dryer off, remove the screen by pulling straight up. 2. Roll the dry lint off the screen. Do not wet the screen or lint; wet lint is hard to remove. Located inside the dryer door. Gives information on what to do if dryer does not perform normally. Model No.