Owners Manual FOR POTABLEWATER HEATING ONLY NOT SUITABLE FOR SPACEHEATING NOT FOR USE IN MOBILE HOMES Model 153.334290 153.334390 153.334490 153.334590 No. 40 30 40 50 Gal. Short Gal. Gal. Gal.
Safety Precautions &WARNING I Improper installation, adjustment, alteration, service or maintenance can cause DEATH, SERIOUS BODILY INJURY, OR PROPERTY DAMAGE. Refer to this manual for assistance or consult your local Sears Service Center for further nformation. AWARNING WATER HEATERS EQUIPPED FOR ONE TYPE GAS ONLY: This water heater is equipped for one type gas only. Check the model rating plate near the gas control valve for the correct gas.
Safety Precautions AWARNING AWARNING A gas water heater cannot operate properly without the correct amount of air for combustion. Do not install in a confined area such a closet, unless you provide air as shown in the "Facts to Consider About the Location" section. Never obstruct the flow of ventilation air. If you have any doubts or questions at all, call your gas company.
Safety Precautions &CAUTION &WARNING WATER HEATERS EVENTUALLY LEAK: Installation of the water heater must be accomplished in such a manner that if the tank or any connections shouldleak, the flow of water will not cause damage to the structure. When such locations cannot be avoided, a suitable drain pan should be installed under the water heater, Drain pans are avail- i able at your local Sears store.
Table of Contents Safety Precautions ................................................................................................... 2_ Table of Contents ................................................................................................... 5 Customer Responsibilities ................................................................................ 6 Product bpecincations ............... 6 :.................................................................................
Customer RespOnsibilities Thank You for This manual contains instructions for the installation, operation, and maintenance of the gas-fired water heater. It also contains warnings through out the manual that you must read and be aware of. All warnings and all instructions are essential to the proper operation of the water heater and your safety. Since we cannot put everything on the first few pages, READ THE ENTIRE MANUAL BEFORE ATTEMPTING TO INSTALL OR OPERATE THE WATER HEATER.
Materials and Basic Tools Needed Materials Needed To simplify the installation Sears has available the installation parts shown below. You may or may not need all of these materials, depending on your type of installation.
Installation Instructions Removing the Old Water OTurn "OFF" Heater ODisconnect the vent pipe from the draft hood where they connect to the water heater. In most installations the vent pipe can be lifted off after any screw or other attached devices are removed. Dispose of the draft hood. The new water heater has the draft hood which must be used for proper operation. the gas supply to the water heater. _,WARNING " [ If the main gas line shutoff serving all g._.
Installation Instructions Facts to Consider Location About the You should carefully choose an indoor location for the new water heater, because the placement is a very important consideration for the safety of the occupants in the building and for the most economical use of the appliance. This water heater is not for use in mobile homes or outdoor installation. Whether replacing an old water heater or putting the water heater in a new location, the following critical points must be observed.
Installation Instructions (cont'd) Combustion Air and Ventilation for Appliances Located in Unconfined Spaces Uncomemed Space is a space whose volume is not less than 50 cubic feet per 1,000 Btu per hour of the aggregate input rating of all appliances installed in that space. Rooms communicating directly with the space in which the appliances are installed, through openings not furnished with doors, are considered a part of the unconfined space.
Installation Water Instructions Piping AWARNING Look at the top cover of the water heater. The cold water inlet is markedcold. Put two or three turns of teflon tape around the threaded end of the threaded_to-sweat coupling and around both ends of the 3A threaded nipple. Using flexible connectors, connect the cold water pipe to the coldwater inlet of the water heater. HOTTER WATER CAN SCAI._. Water heaters are intended to produce hot water.
Installation Instructions (cont'd) Temperature-Pressure Relief Valve _,WARNING _WARNING The temperature-pressure relief valve must be manually operated at least once a yea_ Caution should be taken to ensurethat (I) no one is in front of or aroundthe outlet of the temperature-pressuren.
Installation Filling the Water Instructions (cont'd) Heater I ACAUT,ON For proper venting in certain installations, a larger diameter vent pipe may be necessary. Due to great variances in installations, unforeseeable by the manufacturer of the water heater, you must consult your gas company to aid you in determining tile proper venting for your water heater from the vent tables in the latest edition of the National Fuel Gas Code ANSI Z223.1, also referred to as NFPA 54.
Installation Instructions Venting (cont'd) (cont'd) Gas Piping All vent gases must be completely vented to the outdoors of the structure (dwelliNg). Installonly the draft hood provided with the new water heater and no other draft hood. Vent pipes must be secured at each joint with sheet metal s_rews. &WARNING Make sure the gas suppliedis the same type listed on the modal rating plate. The inlet gaspressuremust not exceed 14 incheswater column ½ poundper squareinch (3.SkPa).
Installation Instructions (cont'd) AWARNING GAS PIPING WITH FLEXIBLE CONNECTOR • The applianceand its individualshutoffvalvemustbe disconnected from the gassupplypipingsystemduringanypressure testing of the gas system at test pressuresin excessof poundper squareinch(3.51dPa). • The appliancemustbe isolatedfrem the gassupplypiping system by dosingits individualmanualshutoffvalveduringany pressuretestingof the gassupply piping systemat test pressuresequalor lessthan '/2poundper squareinch(3.SkPa).
Installation Instructions (cont'd) Installation Checklist BEFORE LIGHTING THE PILOT: VENT PIPE TO OUTDOORS OR CHIMNEY • Check the gas lines for leaks. a. Use a soapy water solution• DO NOT test for gas leaks . using a match or open flame. b. Brush the soapy water solution on all gas pipes, joints and fittings. c. Check,. for bubbling soap. This means you have a leak. Turn OFF gas andmake the necessary repairs. d. Recheck for leaks. e. Rinse off soapy solution and wipe dry. ._.
Operating Instructions Lighting _WARNING BEFORE LIGHTING [PROPANE (LP.) GAS WATER HEATERS]:Propane(LR) gasis heavierthan air. Shouldthere be a leak in the system,the gaswill settle near the ground. Basements,crawl spaces,skirted areasunder mobile homes (evenwhenventilated),closetsandareasbelow_round levelwill serve as pockets for the accumulation of this gas.
Operating Instructions Lighting label on the water FOR YOUR SAFETY (cont'd) heater as it appears above the thermostat READ BEFORE LIGHTING WARNING If you do not follow these instructions exactly, a fire or explosion may resu t caus ng property damage, personal injury or loss of life. A. This appliancehas a pilot which must be lighted by hand.Whenlightingthe pilot,followtheseinstructions exactly. B. BEFORELIGHTINGsmell all aroundtheappliancearea for gas.
Operating Temperature Instructions (cont'd) Regulation Due to the nature of the typical gas water heater, the water ternr petature .... in certain sltuarlons may vary up to 30 DF hight or lower at the point of use such as, bathtubs, showers, sink, etc. Turn the water temperature dial clockwise _./"_) to decrease the temperatm'e, or counterclockwise (("- _"_) to increase the temperature.
Service and Adjustment Tank (Sediment) Burner Inspection Cleaning Sediment build-up on the tank bottom may create varying amounts of noise, and if left in the tank will cause premature tank failure. In some water areas, you may not be able to drain all sediment deposits by simply draining the tank. In these cases Mug Erad (part no. 23600) can be used to help remove the sediment deposits. This may be ordered from the Sears Service Center. For ordering, refer to the Parts Order List section.
Service and Adjustment Drain Valve Washer Replacement Draining The water heater should be drained if being shut down during freezing temperatures. Also periodic draining and cleaning of sediment from the tank may be necessary. • • • • NOTE: For replacement, use a *_" x *Yd'x %"thick washer available at your fiearest hardware store. For ordering replacemerit washers, refer to the "Parts Order List" section. Turn the gas control knob to the "OFF" position.
Troubleshooting Guide Start Up Conditions CONDENSATION THERMAL Whenever the water heater is filled with cold water, a certain amount of condensation will form while the burner is on. A water heater may appear to be leakingwhen in fact the water is condensation, This usually happens when: • When a new water heater is filled with cold water for the first time.
Troubleshooting Guide (cont'd) Operational HOT COLD WATER HEATER • COLD WATER , INLET FITTING SMELLY (3) PRESSURE REDUCING VALVE WITH BYPASS Conditions WATER In each glasslined water heater there is installed at least one anode rod (see "parts section) for corrosion protection of the tank. Certain water conditions will cause a reaction between this rod and the water. The most common complaint associated with the anode rod is one of a "rotten egg smell".
Troubleshooting Operational (cont'd) HIGH Guide (cont'd) Conditions TEMPERATURE SHUT OFF SYSTEM WATER This water heater is equipped with an automatic gas shut offsystern. The high temperature shut off is built into the gas control valve. This system shuts off the gas supply to the water heater burners when high water temperatures are present. It is nonresettable. If the high temperature shut off activates, the gas control valve must be replaced.
Troubleshooting Guide (cont'd) Leakage Checkpoints Use this guide to check a "Leaking"water heater. Many suspected "Leakers" are not leaking tanks. Often the source of the water can be found and corrected. I _,CAUTION Read this manual first.
Parts Order List KENMORE ENERGY EFFICIENT m 5 GAS WATER HEATERS MODEL NUMBERS: 153.334290 153.334390 153.334490 153.334590 40 30 40 50 Gal. Short Gal. Gal. Gal. ! I ] 21 I I ! 19 13 9 26 ] ...... ..
Parts Order List (cont'd) KENMORE ENERGY EFFICIENT TM 5 GAS WATER HEATERS MODEL NUMBERS: 153.334290 153.334390 153.334490 153.334590 40 30 40 50 Gal. Short Gal. Gal. Gal. MODEL NUMBERS KEY NO. 153.334290 PART DESCRIPTION 9000071 153.334390 153.334490 PART NUMBERS 9000071 9000071 9000279 9000279 9000908 9000908 9000058 9000058 153.334590 9000071 1 2 3 4 Temperature-PressureRelief Valve Primary Anode Rod Dip Tube Drain Valve 5 Drain Valve Washer (tT/,, x 'Y.
warranty a. Adjusting thermostat b. Lightingpilot c. Leaksin pipes orfittings d. Improper venting e. Condensation About Your Warranty THE PRICE OF YOUR WATER HEATER DOES NOT INCLUDE A FREE CHECKUP SERVICECALL. On Water Heater Installations Arranged By Sears,Searswarrants the installation. ON INSTALLATIONS NOT MADE BY SEARS AUTHORIZED CONTRACTORS: 1. YourSearswarranty appliesto the product only. 2. Searsdoesnot warrant the installation. 3.