Manual

Unpacking Your Wine Chiller
t. Removeall packaging material Thisincludes the foam and lhe adhesive tape
from a!l outside and insidesurfaces, as we!I as accessories and racks,Slide
out and remove the plastic or foam guard used to protect the compressorfrom
shippingdamage caused by vibration and shock:
2. Inspectand remove any remainingpackaging, tape or printed materials
before powering on the wine chiiler.
3. Check to be sureyou haveall accessoriesand parts listed inthe Partsand
Featuressection.
Proper Air Circulation
To ensure that your wine chilter works at the maximumefficiency it was
designed for, you shouldinstall it ina location where there is proper air
circulation, plumbingand electrical connections.
Thefollowing are recommended clearances around the wine chilter:
Sides...................3/4 inches (19ram)
Top.....................2 inches (50 ram}
Back................ 2 inches (50 mm)
Electrical Requirements
Make sure there is a suitable power outlet (115voltsi t5 amps} with
proper grounding to power thewine chilter.
WARNING: NEVERcut off the third grounding prong from the power cord
plug to accommodate a two prong outlet. Removalof the prong provides no
effective grounding for the appliance, which can result inserious injury or death
from electrical shock
Installation
Your wine chiller is designed for freestanding installationonly.it shouldnot be
recessedor built-in. Placethe wne chi/er on a floor strong enough to support it fully
loaded. When movingthe wne ch iler, never tilt it by more than a 45 degrees angle_This
coutd damage the compressorand the sealed system.
if the wne ch/ler has been tilted more than 45 degrees, let it stand inan upright
position for at least 1 hour prior to plugging it intothe power source This
will ailow the refrigerant to settle and reduce the possibility of a maffunctionin
the caoiing system.
Plugthe wine cf ii/er into an exclusive,properly installed grounded wall outleL
Do not under any circumstancescut or remove the third (grounding) prong from
the power cord See ihe WARNING in Electrical Requirementson the previous
page. Any questionsconcerning power and/or grounding should bedirected
toward a certified electrician or a Searsor other qualified service dealer,
After plugging the appliance into a wall outlet, allow the unitto run for 2 -3
hoursso that the interior is sufficiently coo_before opening the door to place
bottles into the compartment.
Installation Limitations
Do not install your wine chiiier in any location not properly insulatedor heated,
suchas in a garage. Your wine chiller is not designed to operate intemperature
settings below 55° Fahrenheit.
Select a suitable location for the wine chiiier on a hard even surface away from
direct sunlight or heat sourcessuchas radiators, baseboard heaters or cooking
appFances.
7
6/8/10